Fine Effects for the Proper Utility of the Cables

Most sources of the use one or two types of high-voltage connectors (cables), but other types can be installed – standard or according to the customer’s requirements.

In many modular power supplies, the output is a type of high-voltage micro-cable, the length and type of which correspond to the rated output voltage, and which is inextricably connected to the source.

Depending on the model, the cable can be with or without a screen

  • Standard cables have a fixed length; It is possible to supply products with a cable length to order.
  • Most devices designed for higher power are supplied with Spellman’s development and manufacturing cables; these are removable high-voltage switching structures (cable / connector), also known as during connectors.
  • Typically, a deeply recessed socket is located in the source, and a mating part consisting of a coaxial polyethylene cable and a connector is connected to it. On a small section of the cable, the PVC-sheath and the shielding braid are removed, and the polyethylene insulation is bare. The length of the bare part depends on the voltage rating of the source. The high voltage connectors are effective there.
  • At the end of the cable, a fork with spring-loaded contacts is attached to the center of the conductor, and a modified UHF envelope or MS connector is built on the end of the bare part at the end of the cable. This provides a simple and reliable high-voltage connection. The cable is easily connected and disconnected from the device.

The figure below shows a standard removable high-voltage cable. Concerning high-voltage cables and connectors of special and custom execution, please contact the Spellman sales department.

The Complex Mannered Achievements

Works in all directions, as a rule, occur in a complex manner with simultaneous achievement of the set goals, which leads to a significant improvement in quality while reducing the cost of connectors. Reliable electrical connectors are widely used in all industries, as well as in military, aerospace and telecommunications equipment.

For its manufacture, various materials are used, but more often polyvinyl chloride (PVC). Cables with a shell of various colors (black, white and yellowish-brown, gray) are supplied – both for outdoor installation and for indoor installation.

Comments are closed.